EX115/215 Insert Electromagnetic Flow Meter
Seametrics Insert Flow Meter
Electromagnetic Insertion Flow Meter PRODUCT DETAILS
Isolation valve allows installation and removal under pressure
Useful in large water utility pipe and other applications where shutdown is not an option
EX115 fits pipe from 3″ to 10″
EX215 fits pipe from 10″ to 48″
Meter extends only about 1/8 of pipe diameter, minimizing potential for clogging with debris
In most applications, installation tool not necessary due to small tube diameter
Available in brass or 316 stainless steel
Standard valve material is brass, with stainless optional
GENERAL INFORMATION
The complete lack of moving parts of the EX100/200-Series insertion flow sensor is the source of its reliability. Brass and stainless steel models withstand a variety of temperature, pressure, and chemical conditions. The EX-Series has no rotor to stop turning in dirty water and there are no bearings to wear out. Like all magmeters, when used in chemical injection applications, these meters should be installed upstream of the chemical line (or far enough downstream to allow complete mixing of fluids before the meter). A rapidly reversing magnetic field is produced in the lower housing. As the fluid moves through this field, a voltage is generated that is measured and translated into a frequency signal proportional to flow rate. This square wave signal can be sent directly to a PLC or other control or can be converted using any of the Seametrics family of indicators and converters.
